Speedhut SST-MAX OBDII Shift-Light (CAN Protocol) User Manual download pdf

Programming buttons

OBDII

Connector

SST-MAX OBDII Shift Light instructions [CAN (J1979) protocol]

OBDII CAN (J1979) protocol Pinout

If the vehicle has wires that connect to pins 6 and 14 of the OBDII connector

then the vehicle supports the CAN (J1979) protocol.

Pin 4 -- Chassis Ground

Pin 5 -- Signal Ground

Pin 6 -- CAN High (data)

Pin 14 -- CAN Low (data)

Pin 16 -- +12volt Battery power

1. Plug the OBDII connector into the vehicle's ODBII port.

Note: Use the included double sided tape or a screw (not inlcuded). Arrange the shift light cable so that it will not interfere with steering wheel, gear stick, or pedals.

Installation Instructions

1. Disconnect negative (-) Battery Cable

Note: Use the included double sided tape or a screw (not inlcuded).

5. Reconnect negative (-) battery cable.

Red Wire (connect to 12volt power)

White wire (connect to CAN High)

to Shift Light

Black Wire (connect to CAN Low)

Unshielded Wire (connect to Chassis

Ground)

Connect to vehicle’s ODBII port

WARRANTY - Speedhut inc. warrants to the consumer for a period of 5 years from the date of purchase that the product will be free from defects in materials or workmanship.

Speedhut warrants to the consumer for a "LIFE-TIME" that the product circuit board will be free from defects in materials or workmanship.

Please contact Speedhut service department If you have a problem with this gauge.

Speedhut Inc. 165 North 1330 West B2, Orem, Utah 84057 | [email protected] | (801) 221-1460 (9am - 5pm MST)

OPTIONAL: Direct Wire instructions (hard wire the SST-MAX Shift-Light into a PCM/ECU)

Vehicle’s OBDII connector pin numbering

Power Note: There is no need to disconnect the shift light when not in use. The SST-MAX Shift-light will automatically go int

OBDII NOTE: Speedhut SST-MAX Shift-light will not function when used in conjunction with any other OBDII device.

o a power saving mode when the

vehicle is off. When the engine is started up the Shift-light will instantly be powered on and ready to use.

1 2 3

Summary of Contents

Page 1 - Installation Instructions

Programming buttonsOBDIIConnectorSST-MAX OBDII Shift Light instructions [CAN (J1979) protocol]OBDII CAN (J1979) protocol PinoutIf the vehicle has wire

Page 2 - Initial Setup Instructions

Set Shift Point for each Gear Note: Engine RPM will show as this example: 8.35 = 8350 RPM2. Toggle through to set your desired shift point. 3. To save

Page 3

1. Press and hold a button for 2 seconds while viewing the current RPM*. The Peak Recall menu will be displayed.2. Toggle through to to select a gea

Comments to this Manuals

No comments

Speedhut SST-MAX OBDII Shift-Light (CAN Protocol) User Manual

Browse online or download User Manual for For the car Speedhut SST-MAX OBDII Shift-Light (CAN Protocol). Speedhut SST-MAX OBDII Shift-Light (CAN Protocol) User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Speedhut SST-MAX OBDII Shift-Light (CAN Protocol)