Speedhut 2-1_16 inch & 2-5_8 inch Air_Fuel Wide Band User Manual download pdf

Ground (black)

+12 volts Dash lighting (white)

snap connector for dial lighting

1. Disconnect negative (-) Battery Cable

2. Connect wiring as above.

3. Mount Gauge for easy viewing. Use spin lock ring (included) to mount to panel. Spin ring

threads in both directions (depending on your dash panel thickness). Snap Gauge connector to wiring connector

4. Reconnect negative (-) battery cable.

Wide Band controller voltage output

Installation procedure

Note:

Your wide band gauge is calibrated to work with

Innovates 10-18 AF (.880-3.54volts)

Dynojet 10-18 AF ( 0-5volts)

AEM (.5-4.5 volts)

NGK (0-5volts)

PLX (0-4volts)

Note: If your controller has an

anolog (-)ground referance wire

in addition to the main controller

ground this must also be

connected to chassis ground.

NO CALIBRATION REQUIRED. WE HAVE SET UP YOUR GAUGE TO WORK WITH YOUR CORRESPONDING CONTROLLER ALREADY.

Innovate, AEM, PLX, NGK, Dynojet commander - calibration procedure

Note:

Your wide band gauge can be hooked up to the

TPS sensor (Green wire). This is used if you

would like to ONLY have the warning light

come on when in full throttle condition. All

other partial throttle condtions the warning light

will NOT turn on if this wire is attached to the

TPS sensor.

This is used if you ONLY want to be alerted if

your in full throttle condition and the the gauge

moves into the warning region.

2-1/16” and 2-5/8” Wide Band Gauge Instructions

(Gauge Dial lighting)

Note: Tie both lighting white wires together

and both black ground wires together.

INVERTER IS REQUIRED FOR GAUGE DIAL LIGHTING

INVERTER

will remain in last powered position.

+12 volts keyed ignition

(Red)

(Black)

Ground

(White)

+12 volts Dash lighting

(Pointer lighting wire)

(Main gauge power)

(Yellow)

Power Draw = 0.2 Amp

5 Amp Inline Fuse Recommended

for +12 Keyed Ignition

Inverter/Black Box Note: E18-686-5CR is a single gauge inverter to light a single gauge.

C01-18N-2 & C11-18A01 are multiple gauge lighting inverters that can light up to 8 gauges.

***Protect any unused connectors. Damage to an unused connector could cause inverter failure.***

Green Wire (with red stripe)

Throttle Postion Sensor

1 2

Summary of Contents

Page 1 - Throttle Postion Sensor

Ground (black)+12 volts Dash lighting (white)snap connector for dial lighting1. Disconnect negative (-) Battery Cable2. Connect wiring as above.3. Mou

Page 2 - NO Peak Features

Setting warning LED for both low and high. Led can be set to turn on for both a low or high condition, or To reset LED set point at any time follow t

Comments to this Manuals

No comments

Speedhut 2-1_16 inch & 2-5_8 inch Air_Fuel Wide Band User Manual

Browse online or download User Manual for For the car Speedhut 2-1_16 inch & 2-5_8 inch Air_Fuel Wide Band. Speedhut 2-1_16 inch & 2-5_8 inch Air_Fuel Wide Band User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Speedhut 2-1_16 inch & 2-5_8 inch Air_Fuel Wide Band