Speedhut 2-1_16 inch & 2-5_8 inch GPS Speedometer User Manual download pdf

Ground (black)

+12 volts Dash lighting (white)

Peak recall button to recall peak

Snap connection

for dial lighting

+12 Volts keyed ignition

(Red)

(Black)

Ground

(White)

+12 Volts Dash lighting

Power distribution cable to plug all gauges into

Inverter

Note: Tie together the

+12volt dash lighting white

wire to the +12 volt inverter

white wire and connect to

the same dash lighting

source.

+12Volts Hot Start (Red with black)

This feature draws very low current

and will not drain battery under normal use.

1. Hook up speedometer power requirements as shown above.

2. Plug GPS receiver antenna into back of speedometer.

4. Hot start feature is optional. Hooking up the Hot start wire to constant +12volts allows GPS to quickly acquire satellites in less than 2 seconds.

This feature saves your current satellite position within the speedometer enabling it to quickly restore your position on power up when

to the satellites

The current draw is extremely low and will have virtually zero impact on a car battery’s charge.

Hotsart wire should be connected directly to battery +12volts and should remain powered 100% of the time.

3. For best performance, mount GPS antenna with as much view of sky as possible (preferably on the roof of the vehicle). The GPS antenna is

waterproof and magnetic. If the car’s roof is not accessible then mount the antenna on top of the vehicle’s dash with as much exposure as possible

plastic. All types of

metal will block the signal.)

2-1/16” And 2-5/8” GPS Instructions

WARRANTY - Speedhut inc. warrants to the consumer for a period of 5 years from the date of purchase that the product will be free from defects in materials or workmanship.

Speedhut warrants to the consumer for a "LIFE-TIME" that the gauge circuit board will be free from defects in materials or workmanship. Please contact Speedhut service dept.

If you have a problem with this gauge. suppor[email protected]

(Main gauge power)

(Pointer (needle) lighting)

(Gauge Dial lighting)

INVERTER IS REQUIRED FOR GAUGE DIAL LIGHTING

Power Draw = 0.2 Amp

5 Amp Inline Fuse Recommended

for +12 Keyed Ignition

Inverter Note: E18-686-5CR is single gauge inverter to light single gauge.

C01-18N-2 & C11-18A01 are multiple gauge lighting inverters that can light

up to 6 - 8 gauges depending on inverter model.

1 2

Inverter 1

Summary of Contents

Page 1 - Inverter

Ground (black)+12 volts Dash lighting (white)Peak recall button to recall peakSnap connectionfor dial lighting+12 Volts keyed ignition(Red)(Black)Grou

Page 2

Speedometer operationPlug peak recall button in back of GPS speedometer. Press and hold peak recall button down to recall peak.To clear peak , relea

Comments to this Manuals

No comments

Speedhut 2-1_16 inch & 2-5_8 inch GPS Speedometer User Manual

Browse online or download User Manual for For the car Speedhut 2-1_16 inch & 2-5_8 inch GPS Speedometer. Speedhut 2-1_16 inch & 2-5_8 inch GPS Speedometer User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Speedhut 2-1_16 inch & 2-5_8 inch GPS Speedometer